Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
DXF translator need setup file.
- Thread starter fjonsson
- Start date
JohnRBaker
Mechanical
Go to the UGII folder and open the 'ugii_env.dat' file and make sure that the...
# Directory containing the DXFDWG executables.
DXFDWG_DIR=${UGII_BASE_DIR}\dxfdwg\
#
...are set properly.
Of course you will had to have installed the DXFDWG translator for there to be anything there to even point to, and for UGS NX 4 that software came on the translartor CD-ROM and had to be installed separately (for UGS NX 5, it all comes on one DVD-ROM and you can install all of NX in one operation).
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
# Directory containing the DXFDWG executables.
DXFDWG_DIR=${UGII_BASE_DIR}\dxfdwg\
#
...are set properly.
Of course you will had to have installed the DXFDWG translator for there to be anything there to even point to, and for UGS NX 4 that software came on the translartor CD-ROM and had to be installed separately (for UGS NX 5, it all comes on one DVD-ROM and you can install all of NX in one operation).
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
- Status
Similar threads
- Locked
- Question
