Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dual Dimension units

Status
Not open for further replies.

oneeyedwitchdoctor

Mechanical
Joined
Dec 11, 2007
Messages
20
Location
NO
Is it possible to display the units of a dual dimension, ie showing it as [3.00mm] instead of [3.00]
 
GO to the options dialog, "document properties", "Detailing". Under the top level, "Detailing", select the checkbox for "Show units for dual display"
 
Are u running 2008 as I am using 2007 and can't see the check box :-(
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top