Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
DRIVING DIMENSIONS !
- Thread starter coolbe
- Start date
The easiest wayt to do this is to show the assembly level that has both your parts.
Select modify and the features and dimensions that you want to control.
Select SWITCH DIM and note the symbolic values (eg: d12:01) and use these in the relations.
There are other ways, but this is quick and cheap.
Steve
Select modify and the features and dimensions that you want to control.
Select SWITCH DIM and note the symbolic values (eg: d12:01) and use these in the relations.
There are other ways, but this is quick and cheap.
Steve
- Thread starter
- #3
I did try a few times and it worked in the current model only. When I retreave another instanse (assembly) ProE updates session ID's of components, members of the assembly I have placed relation only. All subassembly components remain with session ID's not updated.
I will appreciate any help!
Thanks
I will appreciate any help!
Thanks
- Status