Jun 8, 2001 #1 papajoe Geotechnical Joined Jun 8, 2001 Messages 2 Location US Where can I find the steps or the process of a drilled pier caisson inspection?
Jun 8, 2001 #2 Qshake Structural Joined Jul 12, 2000 Messages 2,672 Location US You need a copy of the FHWA publication: Construction and Design of Drilled Shafts by Reese. Upvote 0 Downvote
Jun 12, 2001 #3 BPin Geotechnical Joined Jun 8, 2001 Messages 2 Location US Another good source of information is the Drilled Shaft Inspector's Manual written by Clyde Baker and published by "the international Association of Drilled Shaft Contractors" (ADSC). Upvote 0 Downvote
Another good source of information is the Drilled Shaft Inspector's Manual written by Clyde Baker and published by "the international Association of Drilled Shaft Contractors" (ADSC).
Jun 12, 2001 Thread starter #4 papajoe Geotechnical Joined Jun 8, 2001 Messages 2 Location US I have found that the Deep Foundation Institute publishes this document. I have ordered it through my company. Thanks. Upvote 0 Downvote
I have found that the Deep Foundation Institute publishes this document. I have ordered it through my company. Thanks.
Jun 13, 2001 #5 KAM_imported Geotechnical Joined Jan 12, 2001 Messages 73 Location US I agree--the bible would be the Drilled Shaft Inspector's Manual, jointly prepared by the DFI (http://www.dfi.org) and the ADSC (http://www.adsc-iafd.com). Upvote 0 Downvote
I agree--the bible would be the Drilled Shaft Inspector's Manual, jointly prepared by the DFI (http://www.dfi.org) and the ADSC (http://www.adsc-iafd.com).