C
cloughna
Guest
So I'm kicking off a new projecft in WF5 (or creo 5.0, if you prefer) which uses the new creo interfaces
My problem is that I cannot seem to set the number of trailing zeroes, nor can I make dimensions show up at all.
Any thoughts on where to dig? I've tried flipping a few config options like tol_display and others, but It doesn't seem to working.
My problem is that I cannot seem to set the number of trailing zeroes, nor can I make dimensions show up at all.
Any thoughts on where to dig? I've tried flipping a few config options like tol_display and others, but It doesn't seem to working.
