Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
drawing threads 3d 2
- Thread starter mcphisto
- Start date
-
1
- #2
-
1
- #3
acaddesigner
Mechanical
I use the spiral program on it makes helixes as well.
I suggest you should extrude a diamond shaped closed polyline along this helix path.
Good luck!
Paul
I suggest you should extrude a diamond shaped closed polyline along this helix path.
Good luck!
Paul
- Status
Similar threads
