G
gbowma
Guest
Is there a way in Creo2 to allow drawing view scales to be fractional? Seems to round up or down. I know it isn't ASME, DOD, etc. approved, but sometimes it's nice to have a scale of 1.5 or whatever.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Similar threads
- Locked
- Question
- Question