Jun 11, 2004 #1 boldfish Mechanical Joined Jan 29, 2003 Messages 101 Location US Is there a way to turn off hatch lines in a section view of an assembly in a drawing?
Jun 11, 2004 #2 ctopher Mechanical Joined Jan 9, 2003 Messages 17,526 Location USA, CA RMB in the hatch area, crosshatch properties, none. Upvote 0 Downvote
Jun 11, 2004 Thread starter #3 boldfish Mechanical Joined Jan 29, 2003 Messages 101 Location US Thanks! I knew the answer would be obvious when I heard it. Upvote 0 Downvote
Jun 11, 2004 #4 ctopher Mechanical Joined Jan 9, 2003 Messages 17,526 Location USA, CA It happens...your welcome Upvote 0 Downvote
Sep 30, 2004 Thread starter #5 boldfish Mechanical Joined Jan 29, 2003 Messages 101 Location US New drawing, new section view. Cross hatch properties is not an option when I RMB. Any idea why? Upvote 0 Downvote
Sep 30, 2004 #6 Mandrake22 Mechanical Joined Jun 21, 2002 Messages 198 Location GB If you are using 2005, the properties are now in a dialog at the LH side of the screen when you LMB the crosshatch area. All the previous controls are still there. If you aren't using 2005 I don't have any ideas. Upvote 0 Downvote
If you are using 2005, the properties are now in a dialog at the LH side of the screen when you LMB the crosshatch area. All the previous controls are still there. If you aren't using 2005 I don't have any ideas.