I have a macro program that creates draw curves, which I use for a graph. Previously, it worked fine, but now with V5 R20, it's acting weird. When I try to reflect the curves about a line, nothing happens. When I save the file, and then re-open it, the curves are gone. Is there something in the tools/options setup that may have changed with the upgrade to R20?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
draw entites won't reflect, and won't save
- Thread starter boffin5
- Start date
Hi,
Its a catvba ? Did you tried to check if all reference libraries are loaded ? Maybe in the previous version you had some other libraries which wasn't loaded with the new version ? Did you tried to run the macro on another computer?
Difficult to say what is wrong.
Regards
Fernando
Its a catvba ? Did you tried to check if all reference libraries are loaded ? Maybe in the previous version you had some other libraries which wasn't loaded with the new version ? Did you tried to run the macro on another computer?
Difficult to say what is wrong.
Regards
Fernando
- Status
Similar threads
- Locked
- Question