Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Drager and building a T-fitting
- Thread starter BetseyO
- Start date
EdStainless
Materials
It is a simple shut off valve and a T and few lengths of tubing. the idea is to release just enough gas through the valve and out the T to allow your Drager to be sampling from ambient pressure.
What oxygen levels are you looking for? You can't get very far with a Drager since it is easy contaminate them with air.
= = = = = = = = = = = = = = = = = = = =
Rust never sleeps
Neither should your protection
What oxygen levels are you looking for? You can't get very far with a Drager since it is easy contaminate them with air.
= = = = = = = = = = = = = = = = = = = =
Rust never sleeps
Neither should your protection
- Status
Similar threads
- Locked
- Question
- Locked
- Question
