Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drager and building a T-fitting

Status
Not open for further replies.

BetseyO

Bioengineer
Joined
Jun 5, 2007
Messages
1
Location
US
thread798-37592

Does anyone know how to build the T-fitting used with the Drager for oxygen testing of gas lines?
 
It is a simple shut off valve and a T and few lengths of tubing. the idea is to release just enough gas through the valve and out the T to allow your Drager to be sampling from ambient pressure.
What oxygen levels are you looking for? You can't get very far with a Drager since it is easy contaminate them with air.

= = = = = = = = = = = = = = = = = = = =
Rust never sleeps
Neither should your protection
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top