Drafting with our company standards

[MFDO]

I’m new to NX and now started detailing a design done outside.

I’ve made Drafting templates with our company standards and would like to appear this standards in the drawings I create. We use non-master model concept (i.e.: Drawing reside in the part file, and therefore I believe that original part standards supersedes our company drw standards).

After bringing the views in to the drawing sheet, do I have to reload our standards manually for each and every drawing? If I have to, how can I automate it? (Run a macro with template open?)


Michael Fernando (CSWE)

http://www.solidCADworks.com

Tool and Die Designer
Siemens NX V8.5 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks

 

[looslib]

Drawing standards in the templates or in the customization menus are only applied to future additions to a file, not existing dimensions, etc.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli

 

[MFDO]

As I said, this is a new drawing creation(=detailing) from the 3D models I received.

Michael Fernando (CSWE)

http://www.solidCADworks.com

Tool and Die Designer
Siemens NX V8.5 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks

 

[SDETERS]

In your 3D model switch to drafting then go to file and then import part. Now import your template prt that you have your title blocks into this part.

 

[SDETERS]

Or you could import the 3D model into your template part also.

 

[eex23]

or use master model concept