Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Downhole temperature rule of thumb

Status
Not open for further replies.

Unotec

Chemical
Joined
Jun 13, 2006
Messages
593
Location
CA
Is there a rule of thumb to estimate downhole temperatures? say, xxxºC/m?
I know that some formations might present higher than normal/expected temperatures due to geological factors, but under normal conditions. Does such a rule of thumb exist?
 
Unotec,
As you mention, conditions vary depending on region, etc., so using a "rule-of-thumb" is risky. A typical downhole logging tool is designed to operate at 20,000 psi and 200C. If you assume a "common" mud weight (12 PPG?) and get a corresponding depth for the 20,000 psi pressure, a temperature gradient could be calculated. Again, this can vary greatly.....
 
Thanks, I actually looked into wells in the sorrounding area and found a trend that seems to work. I verified the downhole temperature of a few of my wells and the prediction was off by a degree or two. Quite acceptable for my purpose.
 
Hi Unotec,
This is old data from Kermit E Brown hand book on Gas lift-

Normal temperature expected in a New Well along Texas & Louisiana Gulf Coast.
74 deg F +1.6 deg F /100 feet.
Example-
Given a 10,000 feet well. What temperature is expected at bottom?
74 def F + 1.6 deg F X (10,000/100)= 74 + 160 = 234 deg F.

Hope this will help.
Regards,
John

 
Western Canadian Sedimentary Basin temperature gradient of 0.036 ?C/m (0.0295 °F/ft)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top