Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Doubt about 3/4 14 DRYSEAL NPSF THREAD 1

Status
Not open for further replies.
maquina01

maquina01

Automotive
Joined
Jun 27, 2009
Messages
3
Location
MX
I have a hole with 3/4 14 npsf thread and verify with L1 and L3 gage, when I veryfied with L1 gage is ok, and when it veryfied with L3, pass through all the hole, what you think is the problem, conicity, big diameter before threaded
 
Sort by date Sort by votes
threads refence off the pitch diameter, not the minor (inner) diameter
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

davidinindy
  • Locked
  • Question Question
Anybody know a manufacturer of 3-1/2" 24V powered rollers?
Replies
0
Views
201
davidinindy
davidinindy
LilyLida
  • Locked
  • Question Question
about the solenoid valves and pneumatic cylinder,could they be replaced by each other
Replies
2
Views
379
LilyLida
LilyLida
Giorgio B.
  • Locked
  • Question Question
Material selection between AISI 316 L / AISI 316 L NACE / Duplex
Replies
1
Views
271
EdStainless
EdStainless
Ferb
  • Locked
  • Question Question
422 stainless
Replies
0
Views
132
Ferb
Ferb
technicaltextile
  • Locked
  • Question Question
idea about effluent treatment at low cost
Replies
1
Views
173
MikeHalloran
MikeHalloran

Part and Inventory Search

Sponsor

Back
Top