Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Double angle sections are always defined by SAP as class-3 per CSA S16-14

Status
Not open for further replies.
JasonMcKee71

JasonMcKee71

Structural
Joined
Feb 13, 2016
Messages
128
Location
GR
Yes, this is right.

Jason McKee
proud R&D Manager of
Cross Section Analysis & Design
Software for the structural design of cross sections
Moment Curvature Analysis
Interaction Diagrams
Reifnorcement Design etc.
 
Status
Not open for further replies.

Similar threads

N
  • Question Question
SAP 2000 - Center of Mass and Center of Rigidity
Replies
0
Views
5K
Neeka
N
a_urbs
  • Locked
  • Question Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs
A
  • Locked
  • Question Question
CSI BRIDGE "Design request" for Precast Concrete I Girder bridge does not work when the defined beam is nonprismatic !!!
Replies
0
Views
884
Abderrahmane Mche
A
giofed
  • Locked
  • Question Question
SAP 2000 Shell twisting moment
Replies
1
Views
1K
JoshPlumSE
JoshPlumSE
Ricyteach
  • Locked
  • Question Question
Select an Area Inside or Bounded by a Closed Frame
Replies
0
Views
906
Ricyteach
Ricyteach

Part and Inventory Search

Sponsor

Back
Top