Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Does galv always have dross and discoloured edges?

Status
Not open for further replies.
Jonhal40

Jonhal40

Industrial
Joined
Aug 21, 2023
Messages
2
Location
CA
I work on an amada ensis3015 3kw we recently started cutting 26ga up to 10ga galvanized, also first time ever working with galvanized. Always have dross and discoloured edges except on the 10 ga I've gotten to cut nice. Anyone have any tips?
 
Status
Not open for further replies.

Similar threads

Gates Fabrication
  • Locked
  • Question Question
thread380-75231 We too have a Mits
Replies
0
Views
742
Gates Fabrication
Gates Fabrication
Darren Bendall
  • Locked
  • Question Question
HI We have a bystronic bystar 3015
Replies
2
Views
1K
Darren Bendall
Darren Bendall
Rana Shafay
  • Locked
  • Question Question
HI Sir I have face a little probl
Replies
7
Views
579
Rana Shafay
Rana Shafay
millerLearn
  • Locked
  • Question Question
Dr. Abe Blank Windows 7- issues in REsult view and output reportd
Replies
0
Views
278
millerLearn
millerLearn
Tony Francis
  • Locked
  • Helpful tip Helpful tip
Dr. Abe Blank Windows 10 - Auto Execute and Make Sheet buttons disabled
Replies
0
Views
505
Tony Francis
Tony Francis

Part and Inventory Search

Sponsor

Back
Top