Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

documentation on SE V7 or higher

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
I found an address on your page of cadcamtraining.com where books are offered. However no success getting in contact with these people. Does somebody have an idea how/where to get these papers (The book about SE V7, The Labwork book about SE V7, the4 university book about SE V8)?
regards, magnus
 
Status
Not open for further replies.

Similar threads

Pulsar123
  • Locked
  • Question Question
Protrusions on curved/lofted surfaces?
Replies
0
Views
820
Pulsar123
Pulsar123
Danu88
  • Locked
  • Question Question
[HELP] Part quantity on single part drawing
Replies
4
Views
711
Danu88
Danu88
garmancm
  • Locked
  • Question Question
Create an "offset hem" or "countersunk lap seam" in SE with Sheet Metal
Replies
2
Views
505
kjoiner
kjoiner
ProEpro
  • Locked
  • News News
Seimens cracking down on unlicensed use
Replies
0
Views
322
ProEpro
ProEpro
NZMark
  • Locked
  • Question Question
Text Profile based on variable string
Replies
2
Views
452
davemerritt
davemerritt

Part and Inventory Search

Sponsor

Back
Top