Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Displaying yield and failure surfaces

Status
Not open for further replies.
MCC1966

MCC1966

Geotechnical
Joined
Jul 30, 2006
Messages
60
Location
CA
Hi
Is there any way where one can display the yield surfaces and/or failure surface.
Thanks
 
Sort by date Sort by votes
For elastic stresses above yield, just reset the maximum Von Mises contour limit to yield.

corus
 
Upvote 0 Downvote
If you use an elastic, plasticmaterial, you can use the Flag variable AC YIELD. Since it's a flag you can set the number of colors to two an use a quiltplot in the contour options.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

F
  • Locked
  • Question Question
How can I obtain integrals over curves and surfaces?
Replies
1
Views
1K
FEA way
FEA way
D
  • Question Question
(ABAQUS) Earlier Failure and Unrealistic Cracking of Reinforced High Strength Concrete Beam Under Bending Simulation
Replies
4
Views
15K
Daniel_LEE
D
E
  • Locked
  • Question Question
Determination of Failure for foundations
Replies
1
Views
995
FEA way
FEA way
jball1
  • Locked
  • Question Question
Connector Damage/Failure
Replies
6
Views
1K
jball1
jball1
Nir_k
  • Locked
  • Question Question
Failure of symmetric boundary constraints in Abaqus
Replies
1
Views
2K
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top