Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Displaying yield and failure surfaces

Status
Not open for further replies.

MCC1966

Geotechnical
Joined
Jul 30, 2006
Messages
60
Location
CA
Hi
Is there any way where one can display the yield surfaces and/or failure surface.
Thanks
 
For elastic stresses above yield, just reset the maximum Von Mises contour limit to yield.

corus
 
If you use an elastic, plasticmaterial, you can use the Flag variable AC YIELD. Since it's a flag you can set the number of colors to two an use a quiltplot in the contour options.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top