Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dish

  • Thread starter Thread starter laelow
  • Start date Start date
Status
Not open for further replies.
L

laelow

Guest
Does anybody know how I would attempt to make a satellite dish in WF 2.0 ?As everybody knows all dishes have different shapes, the one I'm attempting to draw has an ellipse shape to it. If anybody has any idea in which direction i should head i would greatly appreicate it.


smiley11.gif
 
Use WF 2.0 sheetmetal module. It is very easy to create any type of dish in it.


If you can't tell me and I will send you one as reply to this post.


Israr
 
A variable section sweep might also work.
 
Use datum curves to define your ellipse. You will have 3 curves, two the outer portions of your dish and one the cross section through center. You can create either a surface using the curves as boundary curves, or you can create a protrusion as a blend between the three curves.
 
Status
Not open for further replies.

Similar threads

K
  • Locked
Solid Elliptical Dish
Replies
2
Views
3K
trillicomm
T
A
  • Locked
Creating dished surfaces
2
Replies
21
Views
9K
caddict
C

Part and Inventory Search

Sponsor

Back
Top