Generally when a pipeline is protected by impressed current CP system it is required to disconnect the rectifier before starting any welding on the pipeline. Do we need to disconnect a Mag anode system as well. i believe the voltage and current involved is very low in sacrificial CP system and should not be an issue even if we dont disconnect and do welding on the pipeline. is this right?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Disconnecting Cathodic Protection System
- Thread starter mat211743
- Start date
Similar threads
- Question
- Locked
- Question
- Locked
- Question