Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Disable cursor jump in NX 8 sketcher
- Thread starter donrafa7
- Start date
JohnRBaker
Mechanical
I suspect that this has nothing to do with NX, but check this out.
Go to the Windows 'Start' menu and select the 'Control Panel' item and then the 'Mouse' item and on the tab titled 'Pointer Options', check the 'Snap To' option. If it's toggled ON, toggle it OFF, hit OK and see if this solves your problem.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Go to the Windows 'Start' menu and select the 'Control Panel' item and then the 'Mouse' item and on the tab titled 'Pointer Options', check the 'Snap To' option. If it's toggled ON, toggle it OFF, hit OK and see if this solves your problem.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status