Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimensions

Status
Not open for further replies.

Guest
What is the standard for referenceing Dimensions on a mechanical drawing. Like where is the proper place to reference the 0,0 orgin before giving dimensions for mounting holes? What standards can I ref in future for this?
thanks in advance
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The latest and greatest is ASME Y14.5M, basically the same though. "Happy the Hare at morning for she is ignorant to the Hunter's waking thoughts."
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

acesareking
  • Locked
  • Question
Will a groove in a PVC board hold dimensions when the board is bent?
Replies
4
Views
292
3DDave
3DDave
Rogue 1
  • Locked
  • Question
Minimum dimensions of beam for bending test
Replies
3
Views
260
3DDave
3DDave
Helepolis
  • Locked
  • Question
Big Bore Luer-Lock Thread Dimensions? 1
Replies
2
Views
276
IRstuff
IRstuff
Suskam
  • Locked
  • Question
Tolerance for dimensions without a decimal place 1
Replies
11
Views
950
rb1957
rb1957
drennon236
  • Locked
  • Question
Can you calculate dimensions knowing the volume fraction is 0.2?
Replies
1
Views
120
GregLocock
GregLocock

Part and Inventory Search

Sponsor

Back
Top Bottom