Dimensioning Problem

[Dman5]

I have a slight problem using dimension function for this
item. I need to place a dimension parallel to the part and thru the radii centers. I have attached a pic to illustrate. Again, I will need a dimension from top center of radius to bottom center of radius, but not vertical , but parallel to long slightly angled portion.
Thanks much.

 

[SnowCrash]

Create a construction line thru one point, perpendicular to the side of the part. Dimension from the other center to this line.

--
Hardie "Crashj" Johnson
SW 2011 SP 4.0
HP Pavillion Elite HPE
W7 Pro, Nvidia Quaddro FX580

 

[JMarv]

If you dimension between the two sketch points, you can RMB>>Align with edge, after you place the dimension.

Joe
SW Premium 2011 SP0.0
Dell T3500 Xeon W3505 2.4Ghz
6.0GB Win7 Pro x64
ATI FirePro V5800