Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dimensional difference between large male and raised face flange (Part II)
- Thread starter hape6566
- Start date
LittleInch
Petroleum
I think he means this one
The links don't work anymoe though (10 years old).
But from what I can see from ASME B 16.5 figure 6 and table 4, for Large Male there is no dimensional difference between a standard RF face and a "male" Face.
There is though a difference for the Female side and for "small" male faces.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
The links don't work anymoe though (10 years old).
But from what I can see from ASME B 16.5 figure 6 and table 4, for Large Male there is no dimensional difference between a standard RF face and a "male" Face.
There is though a difference for the Female side and for "small" male faces.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Status
Similar threads
- Question
- Locked
- Question