Dimension error

[hemimagnum]

“The Microsoft Jet database engine cannot find the input table or quary ‘ISO_shaft_Fits’. Make sure it exists and that its name is spelled correctly.”

I keep receiving this popup error whenever I enter dimension any part. I also get one for ‘ISO_hole_FITS’

I can click OK on both popups and dimension as normal, but this is getting very annoying.

Any Ideas on what is wrong?

 

[bobsheets]

Hemi;

Please provide your OS, SW ver, PC specs, etc.

 

[hemimagnum]

I am running SW04 SP01 on Windows 2000 with a pent 4 dell laptop, I was running fine untill one day this just started happening. I updated to SP01 thinking it would solve the problem, but it did not help.

 

[SBaugh]

Sounds like something might have corrupted for some strange reason.

Try faq559-507 to see if that fixes it.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[hemimagnum]

No Luck with that, I guess i'll have to try to reinstall.

 

[SBaugh]

With Windows installer you have to reinstall SW to fix the VBA side, which maybe where the problem is at.

You might try and do a repair on SW first. You can do that by going to the Add remove programs and click on change. There you can pick "Repair".

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[bobsheets]

Did you install any other application prior to the time the problem started? MS MDAC components can be over-written by poorly constructed applications. MS took care of this with XP by locking them off.