Dimension arc length in sketch

[jblumka]

How can you make a dimension of arc length in the sketcher?
I know you can dimension both end points and give it a radius, but I need to dimension the length of the arc line.

 

[MrCATIA]

You can dimension the length of an arc on a drawing, but there is no Sketch command to constrain (dimension) the length of an arc.

You could measure the length of the arc while in the sketch.

 

[jblumka]

Ugh.

Thanks for the answer!

I've used SolidWorks for about 10 years, and am now learning CATIA. So far, it sucks.

 

[MrCATIA]

Ha Ha. Give it some time. It's always hard to learn a new system after you've been using the old system for so long (10 years).