Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dim question
- Thread starter ridenrain
- Start date
You have to set this up in your all Templates.
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
faq731-376
Regards,
Scott Baugh, CSWP
faq731-376
- Thread starter
- #3
But where is that toggle/button? I looked in the options for this but found nothing.
I don't think I can change it untill I put in an ordinate dim and that leads me back to turning it off all the time like I am now.
... and why do I have a del link on the word dimension? I sure didn't put it there.
I don't think I can change it untill I put in an ordinate dim and that leads me back to turning it off all the time like I am now.
... and why do I have a del link on the word dimension? I sure didn't put it there.
- Thread starter
- #4
bump...
Can anybody answer this?
To be very clear:
I ordinate dimension a part in a drawing and always have to turn off the "display as a chain" button. I would like this to default to the off position.
From what I can see, this option is only available after the ordinate dims are placed. It cannot be turned off before the ordinate dim is placed.
Can anybody answer this?
To be very clear:
I ordinate dimension a part in a drawing and always have to turn off the "display as a chain" button. I would like this to default to the off position.
From what I can see, this option is only available after the ordinate dims are placed. It cannot be turned off before the ordinate dim is placed.
MElam
Mechanical
- Jan 15, 2004
- 329
Are you using ISO or ANSI as your dimensioning standard?
ANSI does not use this option, and it can not be turned on.
ISO has it on by default and must be turned off each time (sounds like your case)
Check your setting in Document Properties, Detailing, Dimension Standard and make sure it is set to ANSI.
The other question is, which standard are you supposed to be following?
ANSI does not use this option, and it can not be turned on.
ISO has it on by default and must be turned off each time (sounds like your case)
Check your setting in Document Properties, Detailing, Dimension Standard and make sure it is set to ANSI.
The other question is, which standard are you supposed to be following?
- Status
Similar threads
- Locked
- Question
- Question