Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Different groove angles for V belt pulleys

Status
Not open for further replies.
CHARLESCOSTA

CHARLESCOSTA

Structural
Joined
Aug 26, 2007
Messages
27
Location
IN
We are in the practice of giving same groove angles(say38degrees)to both the pulleys(having different dia's) of a transmission pair.However since correct groove angle of pulley depends upon ratio of pitch dia to belt thickness,I feel the two pulleys should have different groove angles(say 38 and 36 degrees)depending upon their pcd/thickness.Can someone please pointout the correct practice.Thanks in advance.
 
Status
Not open for further replies.

Similar threads

Christo_AU
  • Question Question
V-Belt Wear
Replies
6
Views
3K
mfgenggear
mfgenggear
Sicilian Engineer
  • Locked
  • Question Question
Belt Driven Industrial Robotic Concept
Replies
10
Views
4K
XR250
XR250
SAEEDGH
  • Locked
  • Question Question
BELT TIME PULLY PROFILE
Replies
2
Views
403
mfgenggear
mfgenggear
T
  • Locked
  • Question Question
Can gears mesh with different operating pressure angle?
Replies
7
Views
4K
mfgenggear
mfgenggear
Enrico Urru
  • Locked
  • Question Question
Timing belt selection
Replies
3
Views
465
Enrico Urru
Enrico Urru

Part and Inventory Search

Sponsor

Back
Top