Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Difference between Punch & Die and Two Profiles?
- Thread starter babac23
- Start date
srinivasmvv2006
Mechanical
hi,
As i know that people will calls,
male shape profile will be a punch.
female shape profile will be a die.
Punch can be upper die or lower die. In same way die can be upper die or lower die. Its depends on die design or shape of the part.
I will say that call by upper die and lower die instead of calling punch or die.
Thank you,
srinivas
As i know that people will calls,
male shape profile will be a punch.
female shape profile will be a die.
Punch can be upper die or lower die. In same way die can be upper die or lower die. Its depends on die design or shape of the part.
I will say that call by upper die and lower die instead of calling punch or die.
Thank you,
srinivas
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question