detail views

[swforge]

Hi all,
I have a drawing in which I created a section and a detail view from that. I cannot seem to select any feature in the detail view from which to dimension, add centerlines, etc.

Has anyone experienced this before
SW2007
sp4.0

 

[NomLaser]

have to tried to rebuild (CTRL+Q) I haven't seen this issue in the past. You could try to save and reboot and see if that fixes it.

 

[NL8]

swforge,

I've seen this behavior occasionally in SW 2009, but never in 2007. The fix in 2009 is to restart SW and reload the DWG, that's fixed it for me in the past.

Joe Hasik, CSWP/SMTL
SW 09 x64, SP 3.0
Dell T3400
Intel Core2 Quad
Q6700 2.66 GHz
3.93 GB RAM
NVIDIA Quadro FX 4600

 

[energised]

I have had that problem too. I had to add superficial lines to dimension, if I don't have the room to just show the whole view. They are not pinned down so as I work or open/close, they get thrown off.