Detail view not visible when HLR mode is selected

[gonzo1982]

I am not able to view a detail view of a section I had previously created. The dimensions are visible but the part is not.

The part becomes visible when I select the shaded view, but the whole part shows up, not just the detail.

I have tried rebuilding Ctrl+Q and closing the part and opening. Nothing helps.

Thanks.

 

[CorBlimeyLimey]

SW version and SP?
Graphics card and Driver?

Check for shaded detail view in the SW Knowledge Base.

This issue has been identified and assigned to SPR 482569 (Model geometry is shown outside of bounding box when creating a shaded detail view of this part). It occurs when the parent view is shaded or shaded with edges.

A possible workaround is to toggle the display style for the new detail view to a non-shaded style such as HLR and back to shaded or shaded with edges. Then, the geometry will be shown within the detail view bounding box.