Detail View from Break-out not updating (NX7.5.5.4)

[mag00]

I have an old drawing that had some recent changes and one of this changes was a component rotation (3D).

The drawing views was updated fine, but I noticed that a break-out section become out-of-position due to this component rotation, so I edited the break-out section and positioned it in correct place.

This break-out area of drawing was been called in a detail view, and here is the problem. This detail view probably is “converted as independent”. So, the internal lines are not updating with new condition of break-out section.

The view is up-to-date according NX. The clock icon does not appear in navigation panel. Even with this I forced the view update with right click menu "Update View" option.

This can be fixed or I will need to redraw the detail?

Attached is the drawing area with this issue to help the problem visualization (the same image that I put above).

Gerson Fioravanti Junior
Mechanical Production Engineer

 

[Toost]

If you use "Extracted Edges" in your view, try turn these OFF + Update and ON + Update.
Right click the detail, - Style - General - Extracted edges = None + Apply
Extracted Edges = Associative + OK


Regards,
Tomas

 

[mag00]

Thanks for your reply, Tomas.

Unfortunatelly, it was as NONE already. I tried to change settings to ASSOCIATIVE and it not worked too.

Gerson Fioravanti Junior
Mechanical Production Engineer