Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Designing a Pin 1

Status
Not open for further replies.
ToadJones

ToadJones

Structural
Joined
Jan 14, 2010
Messages
2,299
Location
US
I have to check the design of a AISI 1541 pin.

I don't believe this material is covered under AISC or the AISI cold form spec.

Any ideas on how to go about determining the shear capacity?

I have the material properties,...
 
Sort by date Sort by votes
If you take 60% of UTS that should be a good approximation. The 0.57*TYS is another common one. This is from the von Mises/distortion energy/octahedral shear stress criterion. This is technically referred as shear yield strength = 0.577*tensile yield strength.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

EngTal
  • Question Question
Overtightening a bolt beyond its recommended bolt load.
Replies
11
Views
11K
dcascap
dcascap
P
  • Locked
  • Question Question
Welding a member on top of an existing weld
Replies
7
Views
5K
pinaki_stahlbau
P
capntom62
  • Locked
  • Question Question
Finishing a 304 SS welded assembly
Replies
17
Views
1K
EdStainless
EdStainless
struclearner
  • Locked
  • Question Question
Spacer's Dimensions used in a Bolted Joint
Replies
16
Views
2K
mfgenggear
mfgenggear
see_gen_notes
  • Locked
  • Question Question
Does a leger angle anchor produce tension AND shear or it tension OR shear?
Replies
11
Views
5K
kingnero
kingnero

Part and Inventory Search

Sponsor

Back
Top