I am designing a 4 mw furnace to fire woodchip (h.v 2800 kj/kg,moisture 30%)to supply heat for a steam generator.The furnace is step-pushed-grate.Grating ares is 5.2 sq,m. 1.3m width 4m lomg The incline angle is 15. Upper part of the furnace is watercool wall.Lower part is firebrick wall.Every suggestion for this design are welcome.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
design tip for step-pushed-grate
- Thread starter aaaaaaa
- Start date
Similar threads
- Question
- Locked
- Question
- Question
