Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Design Strips in SAFE v12
- Thread starter alphaxy
- Start date
- Thread starter
- #3
Zeemas,
I have my raft foundation which consist of shear walls and columns. how should I place my strips? I'm having a doubtful results as I have used 2 meter auto strips. It gives me 150 - dia 20 which is obviously wrong. As you can see in file attached, I just simplify the layout, but my main concern is in the portion of shear walls and its adjacent columns which safe gives too much reinforcement. Do you have any idea on how to place my design strips to obtain a correct number of reinforcement?
Legend:
Columns = red
Shear wall = blue
Very much appreciated,
AlphaXY
I have my raft foundation which consist of shear walls and columns. how should I place my strips? I'm having a doubtful results as I have used 2 meter auto strips. It gives me 150 - dia 20 which is obviously wrong. As you can see in file attached, I just simplify the layout, but my main concern is in the portion of shear walls and its adjacent columns which safe gives too much reinforcement. Do you have any idea on how to place my design strips to obtain a correct number of reinforcement?
Legend:
Columns = red
Shear wall = blue
Very much appreciated,
AlphaXY
- Status
Similar threads
- Locked
- Question
