Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Design of High Pressure RTJ Girth Flange
- Thread starter ngyc87
- Start date
- Thread starter
- #3
ngyc87,
What's high pressure for you? If design is less than ANSI 1500 class, you might take a serious look at SWG's. There are several variations of the metal o-ring design, the one I most familiar with is nominally called 'helicoflex'. I haven't seen any with pass-partitions, but it shouldn't be too hard. Normally, when I see pass-partitions, they are HE related, and in most cases the right SWG, with internal and external metal rings tend to be the best selection.
rick
What's high pressure for you? If design is less than ANSI 1500 class, you might take a serious look at SWG's. There are several variations of the metal o-ring design, the one I most familiar with is nominally called 'helicoflex'. I haven't seen any with pass-partitions, but it shouldn't be too hard. Normally, when I see pass-partitions, they are HE related, and in most cases the right SWG, with internal and external metal rings tend to be the best selection.
rick
- Thread starter
- #5
- Status
Similar threads
- Question
- Locked
- Question
