Hi, I have been doing the mechanical design of metal internals (like distributor, feed pipe, supports) by considering the allowable stress from ASME II D and checking the loads for allowable deflection specified in datasheet. Now we want to design the same in polypropylene for one of the application. Can I follow the procedure same as metal or are there any other consideration involved? Any help will be appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Design consideration for plastic internals
- Thread starter Vishakash
- Start date
Similar threads
- Locked
- Question
- Question
- Question
- Locked
- Question