Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Design Calculation Tip

Status
Not open for further replies.

gersen

Materials
Joined
Nov 14, 2017
Messages
27
Location
IT
I need some advise with a calculation.
I have 2 round components fixed with a threaded bush.
I want to find a good width for the H dimension.
Do you think Checking the stresses as S = F / (π*D*H) can give a good results or do you have some better calculation method?
Thank you

Immagine2_e32anz.png


The same applies to a situation like this:

Immagine3_uxglg1.png
 
wouldn't the area reacting F be pi*(D^2-d^2)/4 ?
assuming the point to this spacer is to prevent the threaded bush bottoming out.

another day in paradise, or is paradise one day closer ?
 
Shear area pi*D*H?

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top