I am trying to add a force on the tip of the beam angled on the T-section. I am able to draw the actual beam in 2D, but would I create the T-shape in the frame section designer? How could I angle a force on it? I have attached a picture to describe my issue.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Design a force on a T-Beam section
- Thread starter csingh000
- Start date
Knowing the angle, resolve the force into the vertical and horizontal components. Apply these in the model to represent the angled load. You cannot directly input a load on an angle, you need to resolve it into components to be consistent with the coordinate system being used.
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
- Locked
- Question