Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Deposit weld metal thickness with consumable insert

Status
Not open for further replies.
stanweld99

stanweld99

Nuclear
Joined
May 2, 2013
Messages
27
Location
CA
Consumable insert is used for GTAW root pass, and SMAW for the fill pass. In the PQR, if the deposited weld metal thickness for the root pass is t, will the Max deposit thickness be 2t on the WPS for the GTAW process (without filler wire)? Please advise.
 
Status
Not open for further replies.

Similar threads

Karik87
  • Question Question
CVN test at Weld Metal with ER70S-6
Replies
19
Views
11K
weldstan
weldstan
K.P.M.
  • Locked
  • Question Question
Insert plate width reduction
Replies
3
Views
1K
TGS4
TGS4
nashki
  • Question Question
Thickness Hub at the Small End, g0
Replies
5
Views
8K
r6155
r6155
Karik87
  • Question Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
1K
Karik87
Karik87
wdavidchris
  • Locked
  • Question Question
ASME IX - Minimum Groove Weld Thickness for Fillet Weld Qualification
Replies
8
Views
1K
wdavidchris
wdavidchris

Part and Inventory Search

Sponsor

Back
Top