Decimal places in reference dimensions

[dross]

Is there a config option (maybe hidden) that controls the number of decimal places for reference dims that does not affect non-reference dimensions?

I need to have 4 plcs for regular dims, 3 plc for references. It's a pain to constantly change them to 3.

 

[kmdoss1974]

Use mapkey when you want to change a dimension into reference, on the same time change the decimal to 3 plcs.

 

[KK_designer]

default_dec_places its config option for decimal places use: "default_dec_places 2", and you´ll have 0,00

Hope it helps

 

[dross]

THat affects non-reference dimensions also. Not what I want.

default_dec_places its config option for decimal places use: "default_dec_places 2", and you´ll have 0,00

Hope it helps

 

[dr_gallup]

Since it's a reference dimension, the number of decimal places really does not matter. The entire dimension does not matter, it's just there for convenience. However, I understand the need to satisfy some corporate dictate or petty tyrant. I just change them manually since I don't use very many.