Decimal place tolerance for toggle accudraw 1

[lexpamb]

I've recently gotten a new version of microstation and I seem to have misplaced the most basic things, the question is how can I change the decimal point tolerance of the toggle accudraw, from 0.0 to 0 - I remember it being under the workspace drop down, but none of the pop up windows in preference, configuration and customize look at all familiar and I can't seem to figure out where to find it - HELP is being NO HELP! Thanks a lot in advance!

 

[namdac]

lexpamb,
Go to the Accudraw Icon and Right Click on the Icon. Click on properties, Click on the coordinates tab and you will be able to set your tolerance there.
Regards,
Namdac

 

[lexpamb]

I went there and I tried all variations of entering the new decimal places, then ticking and in reverse too but it doesn't seem to change anything. Do you think that's just a default or am I doing something wrong?