Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DEBUG/EPRINT in ADAMS CAR

Status
Not open for further replies.

ichbinpulkit

Automotive
Aug 25, 2023
20
Hello @GregLocock,
You once suggested me to go through the DEBUG/EPRINT. I did, Somehow I am unable to understand how to determine the problem. Should I understand something from the Jakobian Matrix or search the part through it's ADAMS ID and look for what could be wrong.

In this case there is a lot of iterations and also steps then... How can I determine the root of the problem. You can maybe check the .msg file I have attached.

Thanks

Viele Grüße
Pulkit Sharma
 
 https://files.engineering.com/getfile.aspx?folder=e4d8d960-fae9-4fc3-9116-ab645f545f77&file=test_accel.msg
Replies continue below

Recommended for you

The maneuver is finished. Therefore you can interrogate the model by looking at the gra file and plotting stuff.

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376
 
Could you elaborate it somewhat better and deeper?
Why is it not there in the ACAR Help/Guidelines?

Viele Grüße
Pulkit Sharma
 
Thee lines here tell you that the maneuver is over


The maneuver is finished.
command: !
command: stop

Termination status=0



Elapsed time (sec) during dynamic simulation spent in:
Predict Correct Jacobian Eval Solver(NF) Solver(FBS) User Subs Contact
________ ________ _____________ __________ ___________ _________ ________
1.90E-02 1.82E+02 2.33e+01 7.27e+00 2.71E+00 8.79E+00 0.00E+00
0% 99% 12% 3% 1% 4% 0%

Terminating Adams Car usersubs...


Finished -----
Elapsed time = 186.31s, CPU time = 41.95s, Average CPU load = 22.52%


Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor