Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DDmodify

Status
Not open for further replies.
Reaver

Reaver

Electrical
Apr 4, 2006
14
Hello all, back again with a question. I dunno if somebody shares this with me, so I don't know if it's any use for some off you but I like to know it. In Acad 2000i they have changed the change properties, if U use it U will get a big dialog box in your screen and offcourse you can recise it but than it isn't easy to see where you have to go. Now I was very pleased with the ddmodify and ddchprop in acad 14! So I've managed to put these back. DDchprop works like a charme and never crashes, however ddmodify is very unstable and I can't seem to make it work with dimensions at all. This causes Acad to crash, sometimes with normal changes like tekst, and always with dimensions, does anybody has a right way to put it back so it'll work good??

Thx, Reaver :)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom