gregdavison
Mechanical
I have a vertical vessel with 42"-300# blind flange on the top of it. Does anyone have reference to a standard davit design for this size of a flange?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Davit Design
- Thread starter gregdavison
- Start date
- Status
TJOrlowski
Mechanical
How do you want the flange to open? There are several different ways you can do it.
-TJ Orlowski
-TJ Orlowski
- Thread starter
- #3
- Thread starter
- #5
gregdavison
Mechanical
All I have is this one page and it stops at 24" size flange.
TJOrlowski
Mechanical
- Thread starter
- #7
gregdavison
Mechanical
Are you sure this book goes up to the 42"-300# flange size I need the pages I have stop at 24" flanges. This is not something that normally changes in editions of books. Just want to make sure before I spend $.
TJOrlowski
Mechanical
If it doesn't have the design already done for you, it will have the methods for designing a davit that will meet your requirements.
The vessel handbook is one of four books on my desk at all times. In my opinion, a must have for anyone involved with the design, manufacture, or oversight thereof of pressure vessels or heat exchangers.
-TJ Orlowski
The vessel handbook is one of four books on my desk at all times. In my opinion, a must have for anyone involved with the design, manufacture, or oversight thereof of pressure vessels or heat exchangers.
-TJ Orlowski
- Status
Similar threads
- Question
- Locked
- Question