Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Datums help on a simple sheetmetal part

Status
Not open for further replies.
Camo5

Camo5

Mechanical
Sep 30, 2021
1
Hi all, I've started working towards learning my way through the ASME GD&T standards but still having a hard time wrapping my head around setting up my datums. I've got this part that welds to a U shaped tube that goes through both 1/2" holes in the middle, and the large radial cut from the top view sits inside a cylinder, not welded.

Is there another way to set this part up? Have I done it 'right'?

datum_locate_help_xjkcpr.png
 
Status
Not open for further replies.

Similar threads

MattEdwards
  • Locked
  • Question
Datums on thin part
Replies
4
Views
601
drawoh
drawoh
AMontembeault
  • Question
Tapered Datums
Replies
3
Views
4K
AMontembeault
AMontembeault
nmine
  • Question
Slot pattern Datums 2
Replies
7
Views
4K
jassco
jassco
F
  • Question
Profile tolerance unless otherwise specified - WRT Datums vs no datums 1
2
Replies
32
Views
8K
Burunduk
Burunduk
J
  • Locked
  • Question
.140 True Position on a Large Composite Part
Replies
9
Views
3K
JakG
J

Part and Inventory Search

Sponsor

Back
Top Bottom