Jun 2, 2003 #1 D denncoa Guest Hello, Is it possible to show datum points in a full are cross sectional view? Thanks
Jun 2, 2003 Thread starter #2 D dougr Guest Yes as long as the cs isn't total. You'll probably not be satisfied though so suggest putting a draft point on the datum-point and blank them.
Yes as long as the cs isn't total. You'll probably not be satisfied though so suggest putting a draft point on the datum-point and blank them.
Jun 2, 2003 Thread starter #3 D denncoa Guest could you elaborate on the process a little bit more? How do you get them to show up in a cross section? Thanks
could you elaborate on the process a little bit more? How do you get them to show up in a cross section? Thanks
Jun 2, 2003 Thread starter #5 D denncoa Guest For some reason the will not show up on the cross sections. They will however, show up in the regular views. thanks anyway.
For some reason the will not show up on the cross sections. They will however, show up in the regular views. thanks anyway.
Jun 2, 2003 Thread starter #6 D dougr Guest If your points are in front of your section plane then they will not show up... Likewise if you z-clip points, points won't show up behind your z-clip plane.
If your points are in front of your section plane then they will not show up... Likewise if you z-clip points, points won't show up behind your z-clip plane.
Jun 2, 2003 Thread starter #7 D denncoa Guest The datum points were set up directly on the cross section datum planes. I don't believe that I created z-clip points or planes.
The datum points were set up directly on the cross section datum planes. I don't believe that I created z-clip points or planes.
Jun 2, 2003 Thread starter #9 D denncoa Guest I bet that is what my problem is. They are area crosssections. Thank you!
Jun 2, 2003 Thread starter #10 D dougr Guest Datum-curves don't show up on area cs either. To overcome this I use total cs and z-clip to the cs plane. Total cs are by far the most reliable and dependable..
Datum-curves don't show up on area cs either. To overcome this I use total cs and z-clip to the cs plane. Total cs are by far the most reliable and dependable..