I'm trying to create a Datum Point - Offset Ratio - End of Curve - (a straight line length of 50 mm, offset ratio 0.01) and it does not work - point is created at the end of the line. I've checked config.pro and Model Properties - all right. Then I did the same thing, but with Offset Real 0.5 mm (ie, ratio 0.5/50 = 0.01), and everything works (true less than this size again nothing happens). Please help. Thank U.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Datum Point Ratio
- Thread starter mikechy
- Start date
- Status