Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Data to manufacture a helical gear
- Thread starter jackboot
- Start date
Do a search on the American Gear Manufacturers web site - you will find all the standards you need.
- Thread starter
- #3
# of teeth
diametral pitch (or module)
helix angle
hand
normal pressure angle
normal circular tooth thickness
outside diameter
root diameter
normal fillet radius
normal tip radius
these are the minimum callouts you need to define the helical gear geometry completely. Any other specs may be of use for measurement.
diametral pitch (or module)
helix angle
hand
normal pressure angle
normal circular tooth thickness
outside diameter
root diameter
normal fillet radius
normal tip radius
these are the minimum callouts you need to define the helical gear geometry completely. Any other specs may be of use for measurement.
- Status
Similar threads
- Locked
- Question
- Question